Questions? | 973-543-6035 | |

 There will come a time when your garments need cleaning...Please!! :)

Here's How:


Never immerse the brim in water

Needed: pre-treatment stain spray, gentle liquid hand wash detergent & very soft dish brush
1- Spray any stains with the stain spray. Usually the sweatband inside the hat will need attention. Let dry for 10 minutes.
2- Plug the sink and fill half way with cool water and add ¼ cup of liquid detergent. Swish it around you’re your hand.
3- Carefully wash the crown of the hat by hand holding it carefully by the brim and never submerging the brim.
4- Carefully rinse the crown of the hat. Use cool water from the tap.
5- Clean the brim only if necessary. Use the soft dish brush dipped in the detergent water to gently scrub the brim. Do not use any more water than needed and again, never immerse the brim in water.
6- Rinse the brim with the same soft brush method using minimum water.
7- Let air dry



 Never use bleach or fabric softeners

1- Wash in cold water and turn garment inside out. 
2- When drying: turn garment inside out and tumble dry on low heat. Take out damp and let air dry. This prevents shrinkage and helps to keep your print from fading. To avoid possible shrinkage, you can also lay your shirt flat to dry.
3- Do NOT iron in decorated areas
4- Do NOT dry clean 


(Embroidered Patch)

Application Instructions Using an Iron (We Prefer You Sew!) 

1- Set your hand iron at the hottest temperature setting. Do not use steam during application!
2- Place your embroidered patch in the desired position and place a pressing cloth (such as a handkerchief, sheet or pillowcase fabric) over top. 
3- Press the iron straight down for 35-45 seconds with as much constant pressure as possible. No back and forth. 
4- Turn the garment inside-out and repeat steps 2 & 3.
5- Allow the patch to cool down.



Back to Top